* Not all tests are listed in the chart; for reference only.
Universal Type-C charging portRapid charge adaptor for charging at any timeSupplied with a 3.3 ft.(1 m) Type-C rapid charging cable and charging
adaptor, with a universal Type-C charging port for convenient
charging at any time.
Wide range of accessoriesIdeal for most operational requirements24 different types of S2 steel bits in 9 common categories, hardened to a maximum of 60HRC* for toughness and durability.The 2.36in(60mm) magnetic extension rod covers a wide range of applications.Eight different sizes of woodworking bits and metal twist drills meet the requirements for drilling a wide range of materials.Wood drill bitsMetal drill bits
Water-repellent storage pouch*Simple and compact designThe portable storage pouch is made of water-repellent fabric.
The main unit, accessory case, adaptor and charger can all be
stored in the bag, so you can easily and conveniently carry them
all with you.
The main unit, accessory case, adaptor and charger can all be
stored in the bag, so you can easily and conveniently carry them
all with you.
* The maximum torque error is ±5Nm due to the measurement device used. Torque test method: With the battery fully charged, the function selection button is pushed to enter screwing mode. A torque tester is then used to test the locked-rotor torque at level 30.* No-load speed tolerance is approximately 10%. Speed test method: The fully charged device is run for 2 minutes at no load and the no-load speed is then tested with a speed tester.* Screwing test method: With the device fully charged, the gearbox is adjusted to low speed (screwing mode). In manual "M" mode, the tail torque is adjusted to 10 and an M4 x 0.98in.(25mm) self-tapping screw is screwed into the pine board until the battery runs out.*Steel plate drilling test method: With the device fully charged, the gearbox is adjusted to the high-speed setting (drilling mode). In M mode, the tail torque is adjusted to 30 and a hole is drilled into a 6mm-thick steel plate with a 0.24in.(6mm) twist drill.*Wooden board drilling test method: With the device fully charged, the gearbox is adjusted to the high-speed setting (drilling mode). In M mode, the tail torque is adjusted to 30 and a 1.57in.(40mm)-deep hole is drilled into a white pine board with a 0.28in(7mm) wood bit.*The whole unit compliance test report was issued by Waltek Services Test Group Ltd. in Foshan; Test Report No.: WTF21F3015226G.*The whole unit ROHS test report was issued by EMTEK (Dongguan) Technology Co., Ltd.; Test Report No.: ED201110010C.*The EMC test report was issued by EMTEK (Shenzhen) Co., Ltd.; Test Report No.: ES201110017E.*The environmental reliability test report was issued by Intertek Shenzhen Ltd.; Test Report No.: SZHH01513728.*The battery test report was issued by Precise Testing & Certification (Guangdong) Co., Ltd.; Test Report No.: PTC20110204401S-GB01.*The screwdriver bit test report was issued by the National Light Industry Tool Hardware Quality Supervision & Testing Station, Shanghai. Test Report No.: G20201629F. Hardness varies by ±2HRC.* Two extension rod designs are available and will be shipped randomly.* The water-repellent fabric test was conducted by Centre Testing International Co., Ltd. and is waterproof up to class 4–5; Test Report No.: A2210085110101C.